BILSTEIN ENGINE OIL FLUSH MACHINE. OIL CLEAN,
|Back to Service Index||Back to Home||Contact Allstates|
Allstate's Of America, Inc. 800 223 2573, 305 635-4525 Fax 305 635-5353 e-mail Bob@allstates.com http://www.allstates.com
|WE HAVE SOME BEAUTIFUL USED UNITS AVAILABLE AT LOW
Engine Oil Service Solution
From the first mile a vehicle is driven, heat within the engine begins breaking down the oil.
The chemical reaction that occurs creates varnish, then varnish and other contaminants mix
with condensation in the engine to form sludge. It's not long before the passages that
carry the vital engine oil are restricted.
As varnish and sludge build up, friction increases. Timing is affected. Power is lost and fuel
economy deteriorates. Even worse, the contamination begins to clog the oil pick-up screen
- a major cause of engine failure.
The OSS process removes the varnish, carbon, and sludge deposits that regular oil changes
can't touch. The unique OSS cleaner actually dissolves the molecular bond between contaminants
and the internal engine parts.
Dynamic Process - OSS process is done with the engine running, so pressure forces the cleaner
into every oil passage and return galley. The unit's positive suction action circulates the oil
through the unit, removing loosened solids without clogging the screen or damaging seals.
Back Flushes - When the cycle is complete, the engine is turned off and the OSS unit reverses
the flow to be sure no blockage occurs. The cleaning solution with suspended contamination
is purged from the engine, making it simple to install a new filter and add fresh oil.
Fast - The process takes less than half an hour and is self-contained. A powered discharge
transfers waste oil to a storage container quickly and cleanly. Dispose of the waste following
standard waste oil procedures.
Operates on Shop Air - No electrical connection is needed; power is supplied by standard
Diagnostics - With the built-in gauges, you can check the integrity of engine bearings - camshaft,
crankshaft, main and rod bearings. You can also check the oil pump condition and engine
oil pressure to determine if any problems exist.
No. 83000 - Oil contamination removal unit. Wt., 98 lbs. Replacement Part 83020 -
OSS Process Cleaner, 32 oz. (946 ml) bottle,
12 bottles per case.
Oil Changes Are Not Enough
While oil filters remove particulate over 25 microns, sludge, tar, varnish and wear metals less than 25 microns continue to circulate within the engine and accumulate in the passageways, oil pump and oil pan. These contaminates cause engine wear, higher operating temperatures, and reduced lubrication.
Past Procedures Compound the Problem
Simply pouring chemical flush additives into the crankcase is ineffective. Dissolved sludge, particulate and accumulated debris continue to circulate causing significant engine wear.
Bilstein R-2000™ Engine Flush System
This environmentally safe system thoroughly cleans your engine by using patented adaptors and specially formulated solutions to dissolve accumulations of sludge, tar, varnish and wear metals.
The process is performed with the engine off. Using pulsating pressures, the Bilstein R-2000 circulates a heated petroleum distillate solution through the oil pump passage ways and reservoir to dissolve sludge.
A perfectly clean engine means better performance, superior fuel economy and longer engine life.
Restore Engine Efficiency with Total Safety
The Bilstein R-2000 Engine Flush System will not harm your engine, ring seating, valve guides or seals. All residual oil and cleaning solutions are evacuated leaving a light mineral oil on critical wear surfaces.
Periodic Engine Cleaning Extends Engine Life
Tests have shown that periodic sludge removal restores operational efficiencies and reduces harmful exhaust emissions. By reducing wear metals and corrosive contaminates a longer engine life can be expected.
Bilstein - Quality and Reliability
Over the decades, Bilstein has established a solid reputation for quality and reliability. Bilstein products are marketed worldwide only after extensive research and testing.
|INGERSOLL RAND PORTABLE OIL DRAIN
SELF EVACUATING USING COMPRESSED AIR
HIGH QUALITY. SLIGHTLY USED
WE HAVE A LARGE QUANTITY IN STOCK
|Height with bowl at
lowest adjustment: 3-3/4 ft (1143 mm) and Height with bowl at highest
adjustment: 6 ft (1829 mm) 2) Length: 24 in. (610 mm)
List price is $695.00
used in great condition price is only $100.00
Package special. Get two oil drains and one Graco pump for only $300.00
|Graco heavy duty evacuation pump. Model "HUSKY 1040"
New price is $495.00
Very nice condition used price is only $200.00
Premium class. No junk.
Portable Grease Unit
Fully tested PRICED FROM $350.00